Causes of beam splitter failure
Exposure of the reinforcement and concrete to severe environmental conditions could lead to cracking of reinforcements.
Read More
Causes of discharge in tubular busbars
How It Works: A high voltage is applied to the busbar, and PD sensors detect the presence of discharges within the insulation. These discharges are localized and often occur due to voids, cracks, or contamination. Infrared diagnosis of busbar discharge involves temperature measurement, calculation of relative temperature difference (accounting for ambient temperature), and comparison with normally operating busbars. However, the research on this equipment is insuf cient because of the short application and the lack of technical digestion, which has resulted in many accidents. How do you check and maintain busbars? What are the faults of busbar? What is bus bar in DB? For complete safety instructions and precautions, always refer to the test equipment instruction manual. Busbars are critical components in electrical distribution systems, used to conduct large amounts of current and distribute power between electrical devices.
Read More
Causes of Overvoltage on Switchgear Busbar
: Bus overvoltage is primarily caused by switching operations in the power distribution network, lightning strikes, faults in transmission lines, and resonant conditions within the electrical system. Because of this convergence, short circuits located on or near the busbar tend to have very high magnitude currents. My SRT 5kxli had a issue in which dc bus over voltage is occurred in logs and load dropped. This fault has several possible causes and this whitepaper explores each one, ofering solutions to ensure proper VFD operation. Disclaimer: Troubleshooting or servicing a VFD or any electrical equipment should only be performed by qualified personnel familiar with electrical safety practices. Abstract: Covered in this recommended practice is the protection of bus and switchgear used in industrial and commercial power systems.
Read More
Causes of Buried Optical Cable Failures
Underground fiber optic cable systems offer excellent protection and long-term reliability, but they are still vulnerable to various types of failure. Mechanical damage, environmental conditions, improper installation, and lack of testing are among the most common causes. Discover the most common underground fiber optic cable failures, their causes, and how to prevent damage in buried fiber networks.
Read More
Causes of low-frequency vibration in distribution boxes
Vibration is considered the best operating parameter to judge low frequency dynamic conditions such as imbalance, misalignment, mechanical looseness, structural resonance, soft foundation, shaft bow, excessive bearing wear, or lost rotor vanes. In this article, we will explore six key factors that contribute to electrical vibrations in infrastructure. Frequency of Electrical Loads The frequency of electrical loads plays a crucial role in determining the nature and intensity of electrical vibrations. Most industrial vibration faults fall into two frequency categories: 1X RPM (imbalance, bent shaft) and 2X RPM (misalignment). The primary effects of excessive vibration are equipment failure and increased unplanned downtime, leading to substantial financial losses. Various international Original Equipment Manufacturers (OEMs) have developed their own packaging drop and random vibration test standards for their specific distribution cycle, following ship test procedures like ASTM D7386, ASTM D4169 and the ISTA series.
Read More